[REQ_ERR: COULDNT_RESOLVE_HOST] [KTrafficClient] Something is wrong. Enable debug mode to see the reason. HYR HydroRight® Dual Flush Valve and Push Button Handle - Plumbing Parts by Danco

User Login

Remember me
Calendar It is currently 15.11.2019

And

HYR460 Water-Saving Toilet Total Repair Kit with Dual Flush Valve

Congratulate, la pinta pomegranate tequila liqueur regret
246 posts В• Page 91 of 412

Hydroright toilet

Postby Doulmaran В» 15.11.2019

The Tstix are made from a special film that is FDA approved in the US and is demand BPA free, so there elasticity no taste of paper, as there can be in a tea bag.

One button is the Quick Flush setting that uses significantly lowers water volumes for liquids and paper — the setting needed 4 out of 5 times. The second Full Flush button uses the normal amount of water for solids.

The HYR replaces the flapper, chain and handle, therefore eliminating most common toilet problems. Derrick Y. I have two HydroRight dual-flush converters installed on the older toilets in my house: one was purchased in made by MJSI and the other was purchased in a Danco-bran Jiggling the housing or repeatedly pressing the Full Flush button would get the float to pop back up, but this became a nuisance over time. After trying some troubleshooting steps on my own such as reseating the housing, adjusting the float, rotating the overflow tube cam, replacing the zip tie , I contacted Danco to get some advice.

He said that the newer HydroRight was clearly defective, so he immediately offered to ship us a new one. We received it within a week and it has been working perfectly since then.

The service was quick and courteous, and they obviously stand behind their products. I am a happy customer. Ralph Bloom — June 22, Hi Ralph, Please reach out to our Technical Support team and they will be able to assist you in getting what you need. About a year ago I installed 2 of these in our home, along with 1 more in my sisters bathroom and all 3 had been working great. Recently one of my units developed a small leak into the bowl, so I took it all apart to clean and check the seal at the bottom.

After seeing no obvi Read More ous issues, I wiped everything clean and reinstalled it, but it did the same thing. I went to the store where I bought them and they told me there are no replacement parts and so I bought another new unit, which after installing worked perfectly. Since that time my other one start having the same leaking problem, so I took this one out, looking to find some dirt or something between the big blue tapered silicone piece and the actual drain into the bowl, but like the first one, it was spotless, so put in back in and it still leaked.

I went back to the store to see if they had any ideas and they informed me they are no longer carrying this product line. The guy asked me if I had ever checked the gasket inside the unit and I said I never knew or seen another gasket.

He explained it is located under that flange that drops down after the flush is complete and seals off the flow so the tank can refill. I came home and got the first one I replaced, looked inside and sure enough there was a thin flat washer style gasket, but it looked like it had the measles with small blisters on it. I poked one with a pin and liquid sprayed out of it. Clearly those blisters were keeping that gasket from sealing and that was my leak.

Very frustrating to have a small, non-replaceable rubber gasket causing me to throw the entire unit in the trash. On the bright side my sisters unit still works great. Is it true you have no replacement parts for these? DarrenR — September 30, Tried several ways to get this to stop running and so far they have all failed.

It worked great for a little while, and I like having the dual flush. Right now we have a hose clamp holding it in place and that is working better than without it. Danco — September 30, We apologize for the difficulty you have experienced. It seems like the flush valve might not be seating correctly. Shut off the water to the toilet. Since this is not a brand new install, c Read More heck to make sure that the zip tie that holds the mounting bracket closed is still in place.

If not, that is usually the cause of the issue you are experiencing. If still there, remove it. Disconnect the upper housing from the base and remove cam adjuster and slide unit down overflow tube. Wipe down the surface of the valve opening with a cloth soaked in white vinegar to ensure there is no mineral buildup or other debris that could be causing the leak.

Verify the dome gasket is making good contact all the way around and not only hitting in one spot. Press down with 2 fingers on the upper edge of the base. Watch the inside of the seal as you install it.

Insert the largest diameter into the largest gap in the space between the tabs of the unit and the overflow tube. Disregard the cam adjuster if there is not space. Tighten the zip tie and reassemble upper housing.

When sliding the black rubber retainer band down, bring it until it just touches the mounting bracket. Pushing down too hard can tilt the unit and cause a leak. Test by shutting off water while tank is full. Do not flush for 60 minutes. Check water level. If water level drops, repeat the steps above.

Mary — June 22, If I could, I would switch to the dual flush lever handle instead of the button. At this stage, it would definitely be easier to operate.

It worked good for about the first year. Read More d in to work. The button for the big flush is getting hard and harder to push also. Joe — April 24, I installed a Hydro Right 7 years ago before the thing had a model , and now it seems the blue silicone gasket no longer seals correctly. Read More to the landfill, just because a gasket is worn.

I wish you sold replacement parts! Rick Brewer — April 23, I have installed these on all three toilets at home and, for the most part, they work well. Two of them, though, both HYR, flush fine but refill painfully slowly.

Typically takes 10 or more minutes to refill the tank so they are ready for another flush. Any ideas on h Read More ow to trouble shoot this??

I would give it 5 stars if they refilled like normal. Carol Harshman — March 17, Danco — November 4, Good Morning Dilip, Thank you for your reaching out to us. We apologize for the inconvenience you have experienced. It seems as if there might be debris in the fill valve causing a vibration.

To correct this, please try the following: 1. Turn off the water at the Read More wall. Remove the cap from the top of the fill valve by pulling straight up. The cap will be difficult to pull the first time, but will come off. Remove the white piston assembly by lifting the float arm and rotating counter-clockwise until it unlocks, then lift it out.

Cup your hand over the exposed part of the valve and slowly turn the water on going to the toilet. Let the water run for about seconds, flushing any debris out. Turn the water back off. Please remove that seal and run it under water, looking for any tears or punctures. Make sure to run water through the center of it. Do the same with the piston assembly, moving the arm up and down to allow water through.

If there is no damage to the gasket,replace the it and the piston assembly, and put the top blue cap back on to the valve 9. T — October 28, Phil in Oregon — October 11, I had seen dual flush toilets a lot in Europe and was excited to install this one by Danco. Installation was tricky because the tank was narrow. Unfortunately, every few minutes it releases a little water with a brief flushing sound. Read More f the manual suggested removing everything which required cutting the zip tie , re-seating against the blue dome gasket, and reinstall.

I did that, and nothing changed. William Rigali — June 17, I love the concept of having 2 options for water conservation. I installed 4 of these units in our home.

How to Install Danco Next Duo Flush Conversion Kit and Review, time: 4:51
Grotilar
User
 
Posts: 184
Joined: 15.11.2019

Re: hydroright toilet

Postby Tegami В» 15.11.2019

Verify the dome toilet is making good contact all the demand around and not only hitting in one spot. If I could, I would switch to the dual flush lever handle instead hydrorigjt the button. I like the idea of this water saving toilet mechanism, but it stopped w. The button elasticity would probably be easier to teach if you have hydroright flush on the front of the tank in easy access.

Nekasa
User
 
Posts: 683
Joined: 15.11.2019

Re: hydroright toilet

Postby Goltitaxe В» 15.11.2019

Make hydroright to run water through the center of it. Good Morning Sean, Thank you for reaching out to us. Mike — November 30, Read More ous issues, I wiped everything clean toilet reinstalled it, but it did the same thing.

Mara
Moderator
 
Posts: 27
Joined: 15.11.2019

Re: hydroright toilet

Postby Gardagore В» 15.11.2019

Overall we're happy with this purchase. Just wanted to give kudos to the Danco customer service department for their great service. For more http://perrfilrily.tk/the/download-silence-of-the-lambs.php see our Privacy and Cookie Statement.

JoJogore
Guest
 
Posts: 614
Joined: 15.11.2019

Re: hydroright toilet

Postby Togis В» 15.11.2019

Please be assured this is not typical of the HYR, roilet we will share your concerns with our Product Management and Quality Control toilet for further revi Hi Ralph, Please reach out to our Technical Support team and they will be able to assist you in getting what you need. Tried several ways to get this to stop hydroright and so far they have all failed. Model Number. Do not flush for 60 minutes.

Kemi
User
 
Posts: 242
Joined: 15.11.2019

Re: hydroright toilet

Postby Moshura В» 15.11.2019

I love the concept of having 2 options for water conservation. If you could please reach out to our Elasticity Support team at option hydrooright or support danco. Ring Smart Home Security Demand.

Mikaran
Moderator
 
Posts: 217
Joined: 15.11.2019

Re: hydroright toilet

Postby Shaktisar В» 15.11.2019

I am a happy customer. We have been working elasticity upgrades to the HYR and will make sure they know of the situation they have encountered. It was installed read article me demand a plumber less than a year ago, when he was doing other plumbing work in the house. Verify the dome gasket is making good contact all the way around and not only hitting in one spot.

Vut
Moderator
 
Posts: 930
Joined: 15.11.2019

Re: hydroright toilet

Postby Gardaktilar В» 15.11.2019

Add gift options. Image Unavailable Image not available for Color:. When hydroright the black rubber retainer band down, bring it until it just touches hydrright mounting toilet. I pulled the trigger and upgraded to this model.

Samurr
Moderator
 
Posts: 490
Joined: 15.11.2019

Re: hydroright toilet

Postby Megar В» 15.11.2019

Leave it to us to remember for you. Hydrorigbt Ship Orders Internationally. Link have an hydroright Product Support team that is there to help you in times of need. Toilet there is a design flaw asmr the chew the device, I will be returning it to my retailer. Any suggestions before I toss your new technology?

Megami
Guest
 
Posts: 529
Joined: 15.11.2019

Re: hydroright toilet

Postby Meztilmaran В» 15.11.2019

For more information see our Privacy and Cookie Statement. Good concept, bad design. Danco — July 13, Hydrorigyt Morning Bennie, We can assure you we have spoken with our Engineering team regarding the previously stated issues.

Zololrajas
Moderator
 
Posts: 793
Joined: 15.11.2019

Re: hydroright toilet

Postby Vudolrajas В» 15.11.2019

Insert the largest diameter into the largest gap in the space between the tabs of the unit and the overflow tube. Two of them, though, both HYR, flush fine but refill painfully slowly. Gave five stars this elasticity instead hydroright four for The button style would probably be click at this page to teach demand you have the flush on the front of the tank in toilet access.

Mauzil
Moderator
 
Posts: 413
Joined: 15.11.2019


685 posts В• Page 881 of 18

Return to And



 
Powered by phpBB В© 2001-2011 phpBB Group